Club Chopper Forums ychrome  

  
Go Back   Club Chopper > Content > Transmission Rebuild Part 1: The Disassembly

Main Menu
Module Jump:
Change Themes
 Thread Rating: 98 votes, 4.94 average.
Old 04-10-2008, 05:07 PM
179
Member/Admin
 
Scored: 10
Views: 62,576
The Transmission Rebuild



#67 flipped back over...this pic shows the Quad seal, drive spacer, and main seal.



#68 tapping the main seal in, I use a little clear silicone around the outer edge. seems a bit easier to install with the spacer still on the shaft.



#69 shifter shaft and pawl lubed and slipped into the case from the inside. A washer and retaining snap ring is then installed.



#70 new gasket and the two roll pins installed into the case's trap door face. The case is then ready to have the gear-set reinstalled.



#71 the gear-set should slide right into your new counter shaft bearing and main drive gear.



#72 ready to tap onto the roll pins with a rubber mallet. You can see that I still haven't tightened the shaft keeper nuts, although they are loosely on the shafts with each having a spacer behind the nut. To me its easier to tighten these nuts once the trans is somewhat back together. again...alot of this can be done out of order...or in smaller groups for repair.



 

 

Extras
New Article
New Reply

Transmission Rebuild Part 1: The Disassembly
« Previous | Next »

Old 05-05-2008, 08:53 PM
One mile from home.
Awesome job Brad! Read the entire thing and only fell asleep once.

I'm curious about the powder process, they looked to have bead blasted everything?

Clean work bro!
 
 
Old 05-08-2008, 06:03 AM
CC Member/Contributor
yes Markee, i use Powder and Performance Coatings out of Richmond, Va. everything is media blasted.
 
 
Old 05-13-2008, 09:44 PM
CC Member/Contributor
Great thread, very informative! Thanks for sharing.
 
 

Posting Rules
You may not post new articles
You may not post replies
You may not post attachments
You may not edit your posts

Smilies are On
[IMG] code is On
HTML code is On


Category Jump:

Portal > Content > Transmission Rebuild Part 1: The Disassembly


All times are GMT -7. The time now is 11:37 PM.


vBulletin skins developed by: eXtremepixels
Portal By vbPortal Version 3.8.0
Copyright ©2000 - 2019, vbPortal. All Rights Reserved.
The representations expressed are the representations and opinions of the clubchopper.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners or moderators. clubchopper.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you or have been given the expressed written consent to post. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). For full policy, please click the "CC policy" link. Thank you for visiting the clubchopper.com CC Policy

SEO by vBSEO 3.6.0